After weeks of delay, the bamboo plywood I have been waiting for finally arrived. Unfortunately, the convoluted journey it was subjected to because of the failure to arrange for the agreed delivery method in the first place, took its toll. A close look at the photo reveals that the shipping pallet was damaged leaving one corner of the stack unsupported. As a result, the core of the bottom sheet was fractured. The top sheet bears the scars of a forklift suggesting that something was carelessly stacked on top at some point during the transit. Finally, the entire load was left in the rain at some point resulting in water staining on every sheet. Even though each sheet was individually wrapped in plastic, at some point the plastic was sliced along one edge leaving an opening to every panel. It is possible that I will be able to remove some of these stains by sanding them out but that remains to be seen. At $300 a sheet, this damage represent a costly issue. I have started to work with the vendor to make things right. Part of the process was careful documentation. Over the course of 5 hours, I unwrapped each sheet one at a time, photographed the water stains on both sides and placed it onto a new stack. At nearly 40 pounds a piece this was quite the workout. The good news, is that even if I have to cut off the damaged ends, I still have enough material to get started with cabinet making.